Spiral Flush Trim Router Bit with Carbide Inserts, 1/2 Inch Shank x 2-1/6 Inch Cutting Length, Up Ball Bearing and Lower Ball Bearing Template Router Bit for Wood Trim

Bit Specification

Shank Diameter: 12.7 mm ( 1/2" )

Cutting Diameter:  30 mm ( 1-1/6" )

Cutting Length: 55 mm ( 2-1/6" )

Overall Length: 123 mm ( 4-4/5" )

Replaceable Carbide Knives

Size: 12 X 12 X 2.2 mm-35°  Z=4

Quantity: 10 pieces

Material: tungsten carbide

Cutting Edge: 4

Application

Router bits are suitable for cutting softwood, hardwood, plywood, particle board, MDF/HDF, laminate, laminate,  high pressure laminate (HPL), composite decking, acrylic and other.

Applicable machinery: CNC router, fixed base router, plunge router, table mount and handheld router.

Features

Save cutting costs. The spiral flush trim router bit has 10 pieces reversible carbide inserts ( 12mmX12mmX2.2mm-35° Z=4), fixed by the screws. Each blade has 4 cutting edges. You only need to replace the blade on the router bit without replacing the entire drill bit. The ability to replace carbide inserts can extend the life of your milling cutter and save costs in the long run.

Improving flush trim efficiency and productivity. Precision guide bearings make this drill cut smoothly and accurately. There are bottom bearings and top bearings, the template is attached to the workpiece, and guide bearings slide along its edges to form an exact replica of the template. Ideal for template trimming, edge trimming, template wiring, and pattern forming tasks.

Each carbide blade serves four purposes. Once the insert cutter shows signs of wear, you can rotate the carbide insert to get a fresh cutting edge.

Long lasting performance.  Replaceable carbide inserts are made from high quality tungsten carbide. The sharp blade allows for clean cuts and a smooth finish, minimizing tears, chips and burrs. Spiral groove design results in better chip evacuation.

Note

Please install the carbide blade vertically to ensure that the blade is in the same straight line to avoid runout or kickback problems with the router bit.
Please make sure the set screws are tightened before use.
When cutting hardwood, reduce cutting force and proceed slowly.